Building a Segbot (with a Soldered Board)

<- Previous Step    Next Step ->

Preparing the Plastic Shell

This step may depend on where you had the plastic shell of the Segbot fabricated. Ours arrived as pictured below:


Check the shell pieces for any cut pieces that may not have been punched out and remove them. If there is a protective film from production on the shell, remove it. If you have difficulty removing the film, try using a sharp edge or x-acto knife to peel up enough so you can grip it with your fingers to peel the rest off. Our plastic shell ready for assembly is pictured below:


<- Previous Step    Next Step ->

Home ♦ Updates ♦ Videos ♦ Contact Information 

Construction Navigation


Precision. Accuracy. Speed.

University of Illinois at Urbana-Champaign Logo Control Systems Instructional Laboratory
University of Illinois
at Urbana-Champaign
1406 W Green
Urbana, IL 61801-2307